Apply Loctite 262 on threads, and screw the two parts together. Separate the two parts again, to ensure that the threads are filled with Loctite.

Slide the Cone housing over the wire

Open the outer strands one by one. A screwdriver is helpful for this job.

Place the Cone over the center core of the wire, rotating the cone while pushing.

Twist the outer strands back over the cone. Make sure that all strands are evenly distributed over the cone. The end of the wire must be 1½ x the wire diameter over the top of the cone. Check the distance with the calipers.

As a precaution take the terminal apart and visually check that the strands lay evenly around the cone and fit into the wire former (top part). Finally re-assemble as above and allow the Locitite to dry.

The SCT-terminal is designed for use on 1x19 wire construction as well as compacted and Dyform wires. The user is responsible for proper use and installation of the components. Blue Wave does not take responsibility for damaged threads, due to over-tightening or lack of Loctite. Blue Wave does not recommend to seal the terminal, but advise to rinse the terminal regularly with fresh water and treat with WD40.