Blue Wave Stainless Steel Swageless Cone Long Eye

Stainless steel swageless cone long eye terminal.

The long thread terminal, for the swageless Cone range, allows you to replace damaged fittings instantly at sea.

No special tools required!

High polished stainless steel AISI 316.

Part	Wire Ømm	D mm	T mm	KW mm	L1 mm	L2 mm	L3 mm	L4 mm	L5 mm	Break Load KG	RRP Inc VAT	Unit
BW-SC821306-L	6	13	10	17	188	38	14	34	136	5000	£50.92	EACH
BW-SC821307-L	7	13	10	19	212	46	15	38	153	6000	£57.82	EACH
BW-SC821608-L	8	16.5	12	22	252	54	19	46.0	180	8000	£93.91	EACH
BW-SC821910-L	10.0	19.5	16	27	319	64	21	53	235	1100	£106.96	EACH
BW-SC821912-L	12.0	19.5	16	33	362	82	21	56	262	17000	£190.90	EACH

Swageless Cone Terminal

The SCT-terminal is designed for use on 1x19 wire construction as well as compacted and Dyform wires. The user is responsible for proper use and installation of the components. Blue Wave does not take responsibility for damaged threads, due to over-tightening or lack of Loctite. Blue Wave does not recommend to seal the terminal, but advise to rinse the terminal regularly with fresh water and treat with WD40.

Apply Loctite 262 on threads, and screw the two parts together. Separate the two parts again, to ensure that the threads are filled with Loctite.

Slide the Cone-house over the wire

Open the outer strands one by one. A screwdriver is helpful for this job.

Place the Cone over the center core of the wire. Rotating the cone while pushing, will make it easier.

Twist the outer strands back over the cone. Make sure that all strands are evenly distributed over the cone. The end of the wire must be 1½ x the wire diameter over the top of the cone. Check the distance with the caliper.